Directions For Use
EN 31DVDR70 & DVDR75/0x1 3.
52
Direct Record
Can you record the right TV channel in seconds when the DVD recorder is switched off? No
problem. If recording is started manually, the switchedoff DVD recorder takes the current TV
channel from the TV set via the scart cable.
You will find more information on how to switch 'Direct record' on or off in the next section
'Direct record'.
How does Direct Record work?
The DVD recorder compares the TV channel selected on the TV set with its
stored TV channels via the scart cable. If the same TV channel is found, it
switches the DVD recorder to the corresponding programme number and
starts recording.
Please do not change channel on the TV during the search. This could affect
the tuning of the DVD recorder.
?
1 On the TV set, select the programme number you want make the
recording from.
2 Press REC/OTR n with the DVD recorder switched off.
a The display will read 'WAIT'
b The DVD recorder is comparing its saved TV channels with those of the
TV set. Please do not change the TV channel on the TV set while 'WAIT'is
shown in the display.
a
'NOTV' appears in the display
b This TV channel could not be found in the DVD recorder's memory.
Check that all TV channels saved on the TV set are available on the DVD
recorder. If required, save any missing channels. Please read 'Manual TV
channel search' in 'Installing your DVD recorder'.
b Check the connectors at both ends of the scart cable.
b Check your TV's operating instructions to see which scart socket is used
for video signals.
b If the problem persists, you won't be able to use this feature.
Problem
3 Stop recording with STOP h .
Manual recording
51
Automatic recording from a satellite
receiver (Sat recording)
You can use this function if you own a satellite receiver that can control other devices via a
scart cable and a programming function (timer). For more information, please see the operating
instructions for the satellite receiver.
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press SYSTEM-MENU on the remote control. The menu bar
appears.
3 Select '
A
' symbol with D or C .
4 Select 'Record settings' using CH- B or CH+ A and confirm with
C .
5 Select 'Sat record' using CH- B or CH+ A .
6 Select 'EXT2' with D or C .
Switching off 'Sat Recording'
To switch off the function, select 'Off' using C or D .
Tip
7 Confirm with OK .
8 Use a scart cable to connect scart socket EXT 2 AUX-I/O on the
DVD recorder to the corresponding scart socket on the satellite
receiver.
9 To end, press SYSTEM-MENU .
0 Insert a disc you want to use for recording.
A Programme the satellite receiver with the required information
(programme number of the TV channel, start time, end time).
If necessary, please see the operating instructions for your satellite
receiver.
B Switch off the DVD recorder using STANDBY m .'SAT' also
appears in the display to indicate that the function is active.
The DVD recorder is now ready to record. The start and end of the recording is controlled via
scart cable EXT 2 AUX-I/O .
ENGLISH
Manual recording
To Next Page
Loading...
