Technical Alarms (INOPs)
Alarms
5-17
SpO
2
T NOISY SIGNAL
Source - Telemetry
Hard Excessive patient
movements or electrical
interference are causing
irregular pulse patterns
Reduce movement or
electrical noise sources.
SpO
2
T NON-PULSATILE
Note—When paired
directly with an IntelliVue
MP5 Patient Monitor, the
INOP will display as
SpO
2
T SENSOR OFF.
Source - Telemetry
Hard Pulse is too weak or not
detectable
Check connection to patient.
Change sensor site. Avoid
site distal to BP cuff or intra-
arterial line.
SpO
2
T SENSOR MALF
Source - Telemetry
Hard Malfunction of the SpO
2
sensor/adapter cable
Replace sensor.
SRR INTERFERENCE
Source - Patient Monitor
Hard The short-range radio
connection has interference
from another device.
Move transceiver away from
other interference sources. If
INOP persists, contact
Service.
SRR INVALID CHAN
Source - Patient Monitor
Hard The channel configuration
of the short-range radio is
invalid.
Check channel and channel
mask configuration.
Contact Service.
SRR MALFUNCTION
Source - Patient Monitor
Hard There is a malfunction in
the short-range radio
device.
If the INOP persists, contact
Service.
TAAP DISABLED
Source - Patient Monitor
Hard The monitor’s telemetry
configuration does not
allow connection of the
transceiver to the monitor.
Check configuration settings
at the monitor.
Contact Service.
Technical Alarms (Inoperative Conditions)
Alarm Text Priority Condition What to do
To Next Page
Loading...
Need help?
General
