Phoenix Contact AXC F 3152 - Ethernet; Supply Connector; Terminal Point Assignment of the Supply Connector; Terminal Points for the Supply Voltage

Description of the controllers
107708_en_08 PHOENIX CONTACT 39 / 112
3.15.1 Ethernet
The Ethernet network is connected via RJ45 sockets.
3.16 Supply connector
Figure 3-19 Terminal points for the supply voltage (communications voltage U
L
)
Terminal point
assignment
Key:
• Use an Ethernet cable that complies with at least CAT5 of IEEE 802.3.
• Observe the bending radii of the Ethernet cables used.
a1
a2
b1
b2
a1
a2
b1
b2
Table 3-3 Terminal point assignment of the supply connector
Ter mi na l p oi nt Color Assignment
a1, a2 Red 24 V DC (U
L
)
b1, b2 Blue GND
U
L
Communications voltage feed-in (bridged internally)
GND Supply voltage reference potential (bridged internally)