12 Version: 2.0.0 MS205Equ C-863 Mercury Controller
Multi-axis operation of DC and stepper motors
The C-863.11 Mercury DC motor controller has the same command set as the C-
663.11 Mercury Step stepper motor controller. Up to 16 Mercury controllers (for DC
and stepper motors) can be networked and operated via the same computer interface.
Mercury networks are flexible and can also be expanded later on.
Flexible automation
The C-863 presents a number of performance characteristics that make cost-effective
implementation of automation and processing tasks in both research and industry
possible. With the easily understandable programming language macros can be saved
in the non-volatile memory.
A programmable start-up macro makes stand-alone operation possible: The automatic
execution of internal instruction cycles is even performed without external
communication upon switching-on.
Four I/O lines each are used at any one time to easily synchronize motion cycles with
internal or external events. A joystick can be connected for manual control.
User-Friendly: Comprehensive software package and two
interfaces
The controller has a USB interface for easy data exchange with laptop or PC. An RS-
232 interface is also available standard.
The software provided enables the networked operation of multiple controllers.
LabVIEW drivers and a program library make programming system integration easier.
The Mercury controllers can be actuated with the PI General Command Set (GCS)
directly. With PI GCS different PI controllers, like piezo controllers and servo
controllers, can be operated conjointly with minimal programming effort.
To Next Page
Loading...
Need help?
General
