C-863 Mercury Controller MS205Equ Version: 2.0.0 49
Figure 9: Start up controller – Connect controller
2. Select C-863 in the field for controller selection.
3. Select the USB tab on the right side of the window.
4. On the USB tab, select the connected C-863.
5. Click Connect to establish communication.
If communication has been successfully established, the Select connected
stages dialog opens.
If communication could not be established, look for a solution to the problem
in "Troubleshooting" (p. 85).
7.4.3 Establishing Communication for a Networked Controller
The procedure for PIMikroMove and for PITerminal is described in the following.
If you are establishing communication with a networked controller via PITerminal, the
address of the controller to be addressed is required in every command line. Details
see "Target and Sender Address" (p. 69).
Use PITerminal to test communication with networked controllers.
To Next Page
Loading...
Need help?
General
