PI C-863 User Manual

10 Adapting Settings
C-863 Mercury Controller MS205Equ Version: 2.0.0 77
Writing parameters from the volatile memory to the non-volatile
memory
1. Change the parameters in the volatile memory with the SPA command.
2. Check whether the C-863 is operating correctly with the modified parameters.
− If yes:
Write the modified parameter values to the non-volatile memory with the
WPA command.
− If no:
Change and check the parameters in the volatile memory again.
If you are working with PIMikroMove:
 Write the updated values of all parameters to the non-volatile memory:
a) In the main window of PIMikroMove, select the C-863 > Save parameters
to non-volatile memory menu item.
b) When prompted, enter the password 100.
Writing parameters from the nonvolatile memory to the volatile
memory
INFORMATION
 Use this procedure only if you are sure that the C-863 functions correctly with the
parameter values from the nonvolatile memory.
 Write the parameter values from the nonvolatile memory to the volatile
memory with the RPA command.

PI C-863 Specifications

General

Brand	PI
Model	C-863
Category	Controller
Language	English