UPON REPLACING HUB OIL, AVOID THE OIL
COMING INTO CONTACT WITH THE REAR
BRAKE DISC.
Recommended products
AGIP ROTRA 80W-90 Rear hub oil
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Check
- Rest the vehicle on its centre stand on an even surface. - Unscrew the oil dipstick, dry it with a clean
cloth and reinsert it, screwing it in thoroughly.- Take out the dipstick and check that the oil level reaches
the 2nd notch from the bottom.- Screw the dipstick back into place completely.
Recommended products
AGIP ROTRA 80W-90 Rear hub oil
SAE 80W/90 Oil that exceeds the requirements of API GL3 specifications
Locking torques (N*m)
Hub oil drainage plug 15 ÷ 17
Replacement
-Remove the oil cap «A».
- Unscrew the oil drainage cap "B" and drain out
all the oil.
- Screw on the drainage plug and fill up the hub
with oil (about 150 cc)
Air filter
Remove the air cleaner cap after undoing the re-
tainer screws, then extract the filter.
- Wash with water and neutral soap.
-Dry with a clean cloth and short blasts of com-
pressed air.
- Soak with a mixture of 50% petrol and 50% SE-
LENIA AIR FILTER OIL.
Maintenance MP3 125
MAIN - 10
To Next Page
Loading...
