PIAGGIO 633929(IT) - Sealed Battery; Voltage Check; Constant Voltage Battery Charge Mode

Q = Front suspension locking system failure warn-
ing light (if available)
R = Warning light for parking brake engaged
C = High-beam warning light
Pushing the «CLOCK» button for less than 1 second displays the following sequence:
•
TIME
•
DATE
To set the clock push and hold the «CLOCK» button longer than 3 seconds.
The numbers showing the hours will begin flashing.
Set the hour using the «SET» button. Push the «CLOCK» button again and the minutes numbers start
flashing.
Set the minutes using the «SET»button. Push the «CLOCK» button again and the day numbers start
flashing.
Set the day with the «SET» button. Push the «CLOCK» button again and the month numbers start
flashing.
Set the month with the «SET» button. Push the «CLOCK» button again and the year numbers start
flashing.
Set the year with the «SET» button. Press the «CLOCK » button again for 4 seconds to exit the ad-
justment menu.
During the reset process, not pressing any buttons for a period longer than 8 seconds ends the process
automatically and the display shows the modified time.
Sealed battery
If the vehicle is provided with a sealed battery, the only maintenance required is the check of its charge
and recharging, if necessary.
These operations should be carried out before delivering the vehicle, and on a six-month basis while
the vehicle is stored in open circuit.
Besides, upon pre-delivery it is therefore necessary to check the battery charge and recharge it, if
required, before storing the vehicle and, afterwards, every six months.
INSTRUCTIONS FOR THE BATTERY REFRESH AFTER OPEN-CIRCUIT STORAGE
1) Voltage check
Before installing the battery on the vehicle, check the open circuit voltage with a regular tester.
- If voltage exceeds 12.60 V, the battery can be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
- Constant voltage charge equal to 14.40 ÷ 14.70V
-Initial charge voltage equal to 0.3 ÷ 0.5 for Nominal capacity
- Charge time:
MP3 125 Electrical system
ELE SYS - 23