Pioneer MEP-7000 Service Manual

118
MEP-7000
1
2 3 4
A
B
C
D
E
F
1
2 3 4
There are three tools for updating.
Updating in Normal Style mode can be performed with either of the three tools and must be performed
with both the control and drive units connected. Updating in Manipulator Style mode can be performed
only using the Firmware Updating program, which is the only possible way of updating for the SEP-C1.
Updating Tools
A DVD-ROM disc is not
supported.
Firmware
Updating
Program
(DJS)
This program is created from part
of the DJS functions and offered
from the Design Department to
the PSN each time the firmware
is updated.
Remarks
USB storage
device
Format the USB storage device
in FAT/FAT32/HFS+.
Method How to operate
Normal
Style
Manipulator
Style
CD-ROM
(CD-R/RW)
Normal Style mode
Manipulator Style mode (The SEP-C1 is assumed.)
CD-ROM
Connect the USB storage device on
which the
updater files have been
copied to the USB
1 (on the rear) or
USB
2 (on the front) connector of this unit.
Connect the PC and this unit with the
USB cable then activate this program.
(The dedicated USB driver must have
been installed on the PC beforehand.)
Load the CD-ROM (CD-R/RW) to which
the updater files have been copied in the
DVD/CD drive of this unit.
: Recommended
: Possible
: Impossible
Firmware Updating Program (DJS)
Firmware Updating Program (DJS)
USB storage device

Pioneer MEP-7000 Specifications

General

Frequency range	4 - 20000 Hz
Channels quantity	- channels
Digital sound processing	- bit
Total Harmonic Distortion (THD)	0.006 %
Dimensions (WxDxH)	483 x 325 x 91 mm
Power consumption (typical)	33 W

Weight and Dimensions

Weight	6100 g