Pixsys ATR244 - Pre-Programmed Cycle; Soft-Start Type; Soft-Start Reference Command; Soft-Start Gradient

User manual - ATR244 - 55
GROUP Q -
sft.s
- Soft-start and mini cycle
263 Pr. cY. Pre-programmed Cycle
Enables special functionings.
diS a b. Disabled (Default)
Enab. Enabled (all remote sepoint functions are inhibited)
264
SS.TY. Soft-Start Type
Enables and selects the soft-start type
diS a b. Disabled (Default)
Grad. Gradient
P erc. Percentage (only with pre-programmed cycle disabled)
265
ss.r.c. Soft-Start Reference Command (only on ATR-ABC-T)
Defines the reference command for the Soft-Start and the pre-programmed cycle.
cmd. 1 Command 1 (Default)
cmd. 2 Command 2
c m d.1. 2 Command 1 and 2
266
SS. G r. Soft-Start Gradient
Rising/falling gradient for soft-start and pre-programmed cycle.
0..20000 Digit/ora (gradi.decimo/ora se temperatura). (Default: 100.0)
267
SS.Pe. Soft-Start Percentage
Output percentage during soft-start function.
0..100%. (Default: 50%)
268
SS. tH. Soft-Start Threshold
Threshold under which the soft-start percentage function is activated, at starting.
-9999...30000 [digit
1 p. 65
] (degrees.tenths for temp. sensors) (Default: 1000)
269
SS . ti . Soft-Start Time
Max. Softstart duration: if the processs will not reach the threshold selected on par.
SS. tH. within
the selected time, the controller starts to regulate on setpoint.
00:00 Disabled
00:01-24:00 hh:mm (Default: 00:15)
270
M A . ti . Maintenance Time
Maintenance time for pre-programmed cycle.
00:00-24:00 hh.mm (Default: 00:00)
271
FA. G r. Falling Gradient
Falling gradient for pre-programmed cycle.
0 Disabled (Default)
1..10000 Digit/ora
1 p. 65
(degrees.tenths/hour if temperature)
272÷276 Reserved Parameters - Group Q
Reserved parameters - Group Q