Planmeca ProMax 3D Plus - Page 76

• To set date display format:
1. Select User > 1200 Time and Date > 1210 Set System Time and Time /
Date Display Format > Date Display Format.
2. Select the display format you wish to use.
3. Select the green check mark button.
• To set time:
1. Select User > 1200 Time and Date > 1210 Set System Time and Time /
Date Display Format > Change System Time.
2. Use the plus and minus buttons to change the time.
3. Select the green check mark button.
NOTE
The time is set to the local time at the factory. Change the time setting to
show the correct time before you start using the X-ray unit.
11 Settings
72 Planmeca ProMax User's manual