Hand strap
The HANDY TERMINAL comes with Hand strap. You can attach it to the device.
Finger Saddle
This is a slightly depressed and angled area of the back housing that is designed to cradle
or “saddle” your finger while holding the terminal. This unique ergonomic design makes the
terminal comfortable to hold and helps prevent you from accidentally dropping the terminal.
Installed Battery
For information about installing the battery, see Install the Battery on paragraph 3.1.
For information about battery power, see Battery Power on paragraph 4.16.
Speaker
The integrated speaker sounds audio signals as you scan bar code labels and enter data,
but emits no ambient noise on system activity (i.e., processor, memory access, radio traffic,
etc.). The speaker can also be used for playing sounds (e.g., WAV or MP3 files).
The speaker meets the following SPL levels at 10cm:
• 500Hz–80dB
• 1kHz–90dB
• 4kHz–90dB
Stylus and tether
HANDY TERMINAL is shipped with a stylus inserted in a loop on the tether.; see Using the
Stylus on paragraph 3.8.
4.8 Left Side Panel Layout
Side Button
You can set the volume using the Volume Button and scan using the Scan button.
4.9 Installing Memory Cards
The HANDY TERMINAL supports Micro Secure Digital (SD) memory cards up to 32GB. Sandisk,
Kingstone and ATP micro SD recommended
To access the Micro SD card slot and insert the card, proceed as follows:
SCAN button
Volume Up/Down button
To Next Page
Loading...
Need help?
General
