Point Mobile PM60 User Manual

Tab Section Option Description
Basic
Scanning
Trigger timeout (sec)
Specifies the trigger time out in
seconds. If a barcode is not
decoded within the specified
timeout, the default Notifier
indicates that decoding is failed
Enable Auto Scan
Enable Auto Scan with specified
interval.
Auto Scan interval (sec) Set Auto Scan interval time.
Enable Continuous Scan
Enable Continuous Scan without
any interval.
Enable Center Window
(IT5300SR device only)
Enable Center window. Bar
codes are decoded only if they
are within the specified windows
Decode Mode(IT5300SR
device only)
Standard:
Quick Omni
(By default) :
Delay Before
Decoding(IT5300SR
device only)
Start to decoding after specified
milliseconds
Values: 0(default), 100, 200,
300, 400, 500, 600,
700, 800, 900, 1000
Default Enable
Enable/Disable scanner when
the device starts
Wedge mode
Result Type
Select Result Type :
Keyboard Event
Clipboard(default)
Terminator
Select the desired barcode end
method from the pull down list.
Values: None, CRLF, Space
Power Save Options
(N4313 device only)
Power Save TimeOut
(sec)
1~65535
Notification
Beep
If enabled
– plays audio sound
Enable Beep
Set enable/disable plays audio
sound.
Good read Set sound to indicate good read.
Bad read Set sound to indicate bad read.
LED
Enable LED
Set enable/disable visual scan
indicators.
Vibrator
Enable Vibrator
Set enable/disable vibrator
operation.

Point Mobile PM60 Specifications

General

Brand	Point Mobile
Model	PM60
Category	Handhelds
Language	English