23
C.2.D Feed path: Home> Settings> Feeding> Meal times> Feed
Kg of feed to be distributed on daily basis.
By setting 9999 the feed distribution is given at will.
Feed programmed
(Range: 9999K)
C. Settings
C.2.E K count path: Home> Settings> Feeding> Meal times> K count
Active only in a volumetric feed distribution system (no Silo’s load cells in the system).
Press F to run the feed auger for 30 seconds, collect the feed in a
container and weigh it.
ATTENTION: whilst the auger is running the hopper max limit switch
(if present) is NOT ACTIVE!
After 30” this screenshot is displayed:
Enter the weight, in kilos, of feed the auger moved during the 30
second run time. Based upon this setting the feed distribution
system converts the auger running time into kilos of feed distributed
to the animals.
K procedure (start)
(Range: 30”)
K procedure (end)
(Range: 0.0kg...10.0Kg...300.0kg)
By activating this procedure the feed distribution will be stopped (if it’s On); by pressing F it starts for
30 sec then stops and the next screenshot is displayed (the one where you set the Kg of feed downloaded
in 30 sec) then by pressing F the distribution starts again (if it has to).
The input value of KG is archived in par. D.2.1.2 (and it can also be directly inputed).
To Next Page
Loading...
Need help?
General
