66
Make sure the weigher is empty and the readout= 0 (if not then perform
the 'Tare' procedure). Place a known weight on the silo.
If the displayed weight, above, does not match the weight expected,
adjust the displayed weight, using the Decr or Incr keys, to the known
weight value. Press Enter to confirm or Exit to quit without saving.
Silo calibration
By this procedure you can calibrate the weighing system.
D. Installation - Feeding
D.2.1.3.2 Silo calibration
Path: Home> Installation> Feeding> Feed weighing> Silo weighing> Silo calibration
To Next Page
Loading...
Need help?
General
