Introducing the Polycom RealPresence Group Series Systems
Polycom, Inc. 29
Polycom EagleEye Director Indicator Light
The following figure shows the location of the power indicator light on the back of the Polycom EagleEye
Director.
This indicator light provides the following information.
EagleEye Producer Indicator Lights
A light-emitting diode (LED) is integrated into the front of the EagleEye Producer unit. Different LED lights
refer to different system states. These allow you to identify the current system state for the EagleEye
Producer system. Detailed LED and system states mappings are shown in the following table.
Indicator Light System Status
Steady blue light System is on and awake.
Blinking blue light Camera firmware is being updated.
Steady amber light System is asleep.
Steady green light System is in a call.
Indicator Light Status
Steady green light Cameras are ready; camera tracking is off
Steady red light Cameras are powering on
Blinking red light Factory restore on the cameras is starting
Blinking blue light Camera tracking is on
LED System State
Blue Power On, EagleEye Producer Normal State
Blinking Blue On, Not in a Call, Receive IR
EagleEye Producer Boot Up
Fast Blinking Blue Calibrate Webcam Room View
Amber Standby - Asleep
To Next Page
Loading...
Need help?
General
