Security
Polycom, Inc. 147
● ID associated with the session, typically Admin or User
● Remote IP address (that is, the addresses of people logged in to the RealPresence Group system
from their computers)
To view the Sessions List:
» From the local interface, go to Settings > System Information > Diagnostics > Sessions.
» From the web interface, go to Diagnostics > System > Sessions.
Enable Visual Security Classification
This feature helps RealPresence Group system call participants remain conscious of the security
classification when in a BroadWorks managed call. During and throughout a call, the Visual Security
Classification (VSC) provides a visual indication to the RealPresence Group system user of the calls
security level which is dynamically calculated using the lowest security rating of all users and gateways
within the call. During a call, you can override the security classification and assign a lower security
classification level.
Keep the following points in mind:
● Each BroadSoft-registered endpoint in the conference has a security classification level.
● BroadSoft Application Server determines the default security classification level for a BroadWorks
conference, and that default is the lowest of the levels involved in the conference. VSC is only
supported on BroadWorks conferencing systems which are VSC aware and which have visibility of
all participants in the call. VSC is not supported on Polycom VMRs, as BroadWorks does not have
visibility of the callers on the Polycom MCU.
● The security classification level is shared with all the endpoints that support the Visual Security
Classification feature.
● The security classification level of a conference call is re-evaluated whenever an endpoint enters or
leaves a conference or when a user modifies the security classification level of an endpoint.
Any user who joins the call from an outside or unknown network is designated an “Unclassified” security
classification level.
The Visual Security Classification feature is disabled by default. Enable it with a provisioning server or
through the web interface. Before enabling this feature, ensure the following:
● The RealPresence Group system must be registered to a BroadSoft R20 call server.
● The Multipoint Video Conferencing option key must be disabled.
● AS-SIP must be disabled.
To enable Visual Security Classification:
1 From the web interface, navigate to Admin Settings > Security > Global Security.
2 Under Visual Security Classification, select Enable Visual Security Classification and click Save.
3 Under Visual Security Classification, click the Adjust SIP Settings link or navigate to Admin
Settings > Network > IP Network > SIP.
4 Under Registrar Server Type, select Unknown.
To Next Page
Loading...
Need help?
General
