Microphones and Speakers
Polycom, Inc. 95
Ringtone Specifies the ring tone used for incoming calls.
User Alert Tones Specifies the tone used for user alerts.
Audio Mute auto-answered
Calls
Specifies whether to mute incoming calls. Incoming calls are muted until you press
the Mute button on the microphone or on the remote control.
Note: You must first enable Auto Answer Point-to-Point Video or Auto Answer
Multipoint Video. These settings are in Admin Settings > General Settings >
System Settings > Call Settings. For details on these settings, see Configure Call
Settings.
Enable MusicMode Specifies whether the system transmits audio using a configuration that best
reproduces interactive and live performance music picked up by microphones. This
mode provides the highest possible bandwidth for audio.
When MusicMode is enabled, even the faintest musical notes come through clearly.
Note: Automatic noise suppression and automatic gain control are disabled when
MusicMode is enabled.
Enable Keyboard Noise
Reduction and
NoiseBlock™
Specifies whether the system mutes audio from the RealPresence Group Series
microphones when keyboard tapping sounds or other extraneous noises are
detected, but no one is talking. NoiseBlock unmutes the system when speech is
detected, regardless of the existence of background noise.
Note: MusicMode is disabled when this setting is enabled. If an external echo
canceller is used, keyboard noise reduction is not available.
Transmission Audio Gain
(dB)
Specifies the audio level, in decibels, at which to transmit sound. Unless otherwise
advised, Polycom suggests setting this value to 0 dB.
Enable Audio Mute
Reminder
Specifies whether to display a notification as a reminder to unmute the
RealPresence Group system microphone when speaking is detected.
Enable Join and Leave
Tones
Plays an audible tone when a participant in a multipoint call joins or leaves the call.
Note: This setting is available only when the multipoint option is installed.
Enable Acoustic Fence Specifies whether Acoustic Fence can be used or not. For details on Acoustic
Fence, refer to Acoustic Fence Technology.
Acoustic Fence Sensitivity Specifies the microphone sensitivity for Acoustic Fence Technology. You can set a
value between 0 and 10, where 0 is the minimum sensitivity and 10 is the maximum
sensitivity. Higher settings increase the radius of the fence area around the primary
microphone.
Setting Description
To Next Page
Loading...
Need help?
General
