Polycom Vortex EF2210 - Page 4

8.59. LAGCRATE -- Set Ramp Rate of Line Input AGC
8.60.
MACROA -- Add Command to Current Macro
8.61.
MACROK -- Delete One or All Macros
8.62.
MACROL -- List All Commmands in a Macro
8.63.
MACROQ -- Execute Macro Quietly
8.64.
MACROS -- Start a New Macro
8.65.
MACROW -- Write Macro to Non-Volatile Memory
8.66.
MACROX -- Execute Macro
8.67.
METER -- Select which Signal is Displayed on the Front Panel LED Meter
8.68.
MGAIN -- Set Crosspoint Gains in Main Matrix or Submatrix
8.69.
MGATE -- Select Gated or Ungated Microphone Signal in Matrix
8.70.
MIC -- Enable Microphone Gain Stage on Input 1
8.71.
MINI -- Enable Modem Initialization String
8.72.
MINISTR -- Set Modem Initialization String
8.73.
MMUTE -- Mute Crosspoint in Main Matrix or Submatrix
8.74.
MUTEGIL -- Set Mute Status of Line Inputs as a Group
8.75.
MUTEI -- Mute One or More Inputs
8.76.
MUTEO -- Mute One or More Outputs
8.77.
NC -- Enable Noise Cancellation
8.78.
NCL -- Set Noise Cancellation Attenuation
8.79.
NVINIT -- Reinitialize Non-Volatile Memory
8.80.
NVLOCK -- Lock/Unlock Non-Volatile Memory
8.81.
NVPSWD -- Change Non-Volatile Memory Password
8.82.
PEQIA -- Set All Parameters for Specified Parametric EQ Input Stage
8.83.
PEQIB -- Set Bandwidth Parameter for Specified Parametric EQ Input Stage
8.84.
PEQIE -- Set Enabled Parameter for Specified Parametric EQ Input Stage
8.85.
PEQIF -- Set Frequency Parameter for Specified Parametric EQ Input Stage
8.86.
PEQIG -- Set Gain Parameter for Specified Parametric EQ Input Stage
8.87.
PEQIS -- Set Slope Parameter for Specified Parametric EQ Input Stage
8.88.
PEQIT -- Set Type Parameter for Specified Parametric EQ Input Stage
8.89.
PEQOA -- Set All Parameters for Specified Parametric EQ Output Stage
8.90.
PEQOB -- Set Bandwidth Parameter for Specified Parametric EQ Output Stage
8.91.
PEQOE -- Set Enabled Parameter for Specified Parametric EQ Output Stage
8.92.
PEQOF -- Set Frequency Parameter for Specified Parametric EQ Output Stage
8.93.
PEQOG -- Set Gain Parameter for Specified Parametric EQ Output Stage
8.94.
PEQOS -- Set Slope Parameter for Specified Parametric EQ Output Stage
8.95.
PEQOT -- Set Type Parameter for Specified Parametric EQ Output Stage
8.96.
PHANTOM -- Enable Phantom Power on Input 1
8.97.
PING -- See Which Devices Are Present
8.98.
PRESETK -- Delete One or All Presets
8.99.
PRESETL -- List All Commmands in a Preset
8.100.
PRESETP -- Set Which Preset Will Be Activated At Power-Up
8.101.
PRESETQ -- Execute a Preset Quietly
8.102.
PRESETW -- Save a Preset
8.103.
PRESETX -- Execute a Preset