Power Electronics SD300 Series - Page 163

POWER ELECTRONICS
SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
161
Screen
Description
Default
value
Range
Function
Set
on
RUN
In.41
[25]
V2 maximum
reference
100.00%
0.00 to
100.00%
Set the speed reference corresponding to the
analog input 2 maximum range. It corresponds
to the maximum current level set in In.40. It is
configured to introduce the speed reference
through the analog input. The value is a
percentage of the frequency adjusted in
parameter In.1.
YES
In.46
[25]
V2 Inverting
N
NO
YES
Same as In.16, but for the voltage analog input
2.
YES
In.47
[25]
Adjust I2
visualization
0.04
0.04 to
10.00%
Same as In.17, but for the voltage analog input
2.
YES
In.50
[26]
I2 Monitor
0.00mA
0.00 to
24.00mA
Used to monitor current analog input 2.
NO
In.52
[26]
I2 filter
10ms
0 to
10000m
s
Configures the time for the operation
frequency to reach 63% of target
YES
In.53
[26]
I2 minimum
current
4.00mA
0.00 to
20.00mA
Same as In.38, but for the current analog input
2.
YES
In.54
[26]
I2 minimum
reference
0.00%
0.00 to
100.00%
Same as In.13, but for the current analog
input 2.
YES
In.55
[26]
I2 maximum
current
20.00mA
0.00 to
24.00mA
Same as In.40, but for the current analog
input 2.
YES
In.56
[26]
I2 maximum
reference
100.00%
0.00 to
100.00
Same as In.11, but for the current analog
input 2.
YES
In.61
[26]
I2 Inverting
N
N
Y
Same as In.16, but for the current analog input
2.
YES
In.62
[26]
Adjust I2
visualization
0.04%
0.04 to
10.00%
Same as In.17, but for the current analog input
2.
NO
[25] Displayed when V is selected on the analog current/voltage input circuit selection
switch (SW2).
[
26
] Displayed when I is selected on the analog current/voltage input circuit selection
switch (SW2).