Power Electronics SD300 Series User Manual

SD300
POWER ELECTRONICS
204
DESCRIPTION OF PROGRAMMING PARAMETERS
Screen
Description
Default
value
Range
Function
Set on
RUN
Pr.61
[35]
Capacitor
diagnosis
mode
+0%
0 to 3
This parameter allows performing a
capacitor diagnosis
To perform a capacitor diagnosis, the
capacitance reference must be established
by setting this parameter to 1 when the drive
is used for the first time. The measured
reference is saved in Pr. 63 and will be used
as reference for the diagnosis.
OPT.
DESCR.
0
Nonde
1
RefDiag (*)
2
PreDiag
3
InitDiag
(*) Note: This option is used to set a
capacitance reference. It is recommended
to use it when the drive is operated for the
first time.
NO
Pr.62
[35]
CAP
exchange
warning level
0%
[36]
50.0 to
95.0%
Sets the capacitor exchange warning level.
The warning “ECAP” will be displayed when
this value is reached.
NO
Pr.63
[35]
Capacitance
reference
0.0%
[36]
0.0 to
100.0%
This parameter shows the capacitance
reference measured in Pr.61. This value
must be equal to 100.0% when the drive is
operated for the first time.
YES
Pr.66
Braking
resistor
configuration
+0%
0 to 30%
Set braking resistor configuration (%ED:
Duty cycle). Braking resistor configuration
sets the rate at which the braking resistor
operates for one operation cycle.
YES
Pr.73
Speed
deviation fault
N
N
Y
Fault due to speed deviation.
YES
Pr.74
[36]
Speed
deviation band
50
1 to 20
Speed deviation band.
YES
Pr.75
[36]
Speed
deviation time
60
1 to 120
Speed deviation time.
YES
[
35
] These parameters are displayed when Pr.60 is set to more than 0.
[
36
] Displayed when Pr.73 is set to YES.

Power Electronics SD300 Series Specifications

General

Brand	Power Electronics
Model	SD300 Series
Category	Inverter
Language	English