Installation and Operation Manual Page 80 of 104
(PVI-3.8/4.6-I-OUTD-US Rev.: 1.1)
2) Contrast: Display light contrast
Available display light tones go from 0 to 9.
Press UP and DOWN keys to scroll the numbers and then press ENTER to confirm the
selection.
3) Buzzer: Key tone setting
Selecting:
ON: The key tone is on
OFF: The key tone is off
5.4.6.3 Service
Only installing staff can gain access to this function. It is password-protected and the
dedicated code is supplied by Power-One.
5.4.6.4 New Password
This function is used to change the default password 0000.
To set your personal code, use the display keys as follows:
Use ENTER to move from one digit to the next (from left to right)
Use ESC to go back to the previous digit (from right to left)
Press ESC repeatedly to go back to the previous menus as described in
section 5.5.3
Press DOWN to scroll numbers backwards (from 9 to 0)
Press UP to scroll numbers forwards (from 0 to 9)
NOTE
:
Save new password in a safe place!!!
5.4.6.5 Cash
This function is about energy output earnings.
Name: Set desired currency, using the keys in the usual manner. The default currency
is the Euro.
Val/KWh: This indicates the cost of 1 kWh expressed in the currency set. The default
setting is Euro 0.50.
Name EUR
To Next Page
Loading...
