Installation and Operation Manual Page 84 of 104
(PVI-3.8/4.6-I-OUTD-US Rev.: 1.1)
This function is used to set the time interval for system maximum multiple scan. The
default setting is 15 minutes.
5.4.6.13 Alarm Message
Use the following procedure to program the error message shown on the display:
Press the ENTER key to open the relevant submenu
Select the desired function with the arrow on the left side of the display, scrolling it
with the UP (2
nd
key) and DOWN (3
rd
key) display keys. When the chosen item is
selected, press ENTER (4
th
key) to confirm activation of the chosen mode.
The following screen will appear in the ENABLE/DISABLE menu. Here you can
enable or disable the customized message settings function:
With arrow in line with the ENABLE MESSAGE line, press ENTER and go to the
next screens for writing the message.
Enable / Disable
To Next Page
Loading...
