EasyManua.ls Logo

Printronix S828 - Page 108

Printronix S828
424 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ProgrammerManual PTXS828
Chapter4IPDSCommands 106 260071001A
Table 4. IPDS Command Code Summary for 828 IPDS Printer (continued)
Cmd Hex Code Description Initial State Ending State
WBCC D680 Write Bar Code Control Page, Page Segment, Page Bar Code Block, Page
or Overlay Segment Bar Code Block, or
Overlay Bar Code Block
WBC D681 Write Bar Code Page Page Bar Code Block, No Change
Page Segment Bar Code
Block, or Overlay Bar
Code Block
WGC D684 Write Graphics Control Page, Page Segment, Page Graphics Block, Page
or Overlay Segment Graphics Block,
or Overlay Graphics Block
WG D685 Write Graphics Page Graphics Block, No Change
Page Segment Graphics
Block, or Overlay
Graphics Block
WIC D63D Write Image Control Page, Page Segment, Page Image Block, Page
or Overlay Segment Image Block,
or Overlay Image Block
WI D64D Write Image Page Image Block, Page No Change
Segment Image Block,
or Overlay Image Block
WT D62D Write Text Page, Page Segment, No Change
or Overlay
BO D6DF Begin Overlay Home Overlay
DO D6EF Deactivate Overlay Home Home
IO D67D Include Overlay Page or Overlay No Change
BPS D65F Begin Page Segment Home Page Segment
DPS D66F Deactivate Page Segment Home Home
IPS D67F Include Page Segment Page or Overlay No Change
LE D61D Load Equivalence Home Home
LFE D63F Load Font Equivalence Home, Page, Page No Change
Segment, or Overlay
DF D64F Deactivate Font Home Home
END D65D End See Note 2 See Note 2
Notes:
1. The Discard Buffered Data subcommand in the Execute Order Any State command causes the printer to
enter the home state.
2. The End command is valid in any page block, overlay block, or page segment block state and causes the
printer to return to the corresponding page, overlay, or page segment state.
Figure 11 shows all of the IPDS states and their commands. Notice that some commands can only occur in a
specific state, some commands can occur in more than one state, and some commands can occur in any
state. Also note that the printer can only enter the page state, the page segment state, and the overlay state
from the home state.

Table of Contents

Related product manuals