Printronix S828 - Range; Sets Printing Style. (EPSON)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  30 260071‐001A
ESC !
Sets printing style. (EPSON)
ASCII Code ESC ! n
Hexadecimal Value X'1B' X'21' n
Decimal Value 27 33 n
This command is used to select any valid combination of printing attributes. Each printing attribute is
selected by the nparameter, as specified in the following page:
n Attribute
0 10 cpi
1 12 cpi
2 Proportional
4 Compressed
8 Emphasized
16 Double Strike
32 Double Width
64 Italics
128 Underline
To print the desired combination of printing attributes, calculate the nparameter by adding up the values of
each attribute.
ESC(-
Sets score line. (EPSON)
ASCII Code ESC ( - n1 n2 md1 d2
Hexadecimal Value X'1B' X'28' X'2D' n1 n2 md1 d2
Decimal Value 27 40 45 n1 n2 md1 d2
Range n1 =3
n2 =0
m=1
1 = d1 = 3
d2 =0,1,2,5,6
This command enables or disables scoring of all characters and spaces following the command according
to the following parameters:
d1 Line
1 Underline
2 Strikethrough
3 Overscore