Printronix S828 - Native Character Set

ProgrammerManual PTX‐S828
Chapter2NativeEmulationCommands 58 260071‐001A
DC4 DC4 ESC 3 6
Sets vertical spacing 6 lines/30 mm.
ASCII Code DC4 DC4 ESC 3 6
Hexadecimal Value X'14' X'14' X'1B' X'33' X'36'
Decimal Value 20 20 27 51 54
This command sets vertical spacing to 6 lines per 30 mm.
DC4 DC4 ESC 3 8
Sets vertical spacing 8 lines/30 mm.
ASCII Code DC4 DC4 ESC 3 8
Hexadecimal Value X'14' X'14' X'1B' X'33' X'38'
Decimal Value 20 20 27 51 56
This command sets vertical spacing to 8 lines per 30 mm.
DC4 DC4 ESC A
Sets the horizontal spacing to 15, 17.1, 20 CPI.
ASCII Code DC4 DC4 ESC A n
Hexadecimal Value X'14' X'14' X'1B' X'41' n
Decimal Value 20 20 27 65 n
This is terminator code and causes the current contents of the print buffer to be printed. The subsequent
characters are printed at the horizontal spacing specified by the n parameter.
n Spacing
4 15 cpi
5 17 cpi
6 20 cpi
Native Character Set
DC4 DC4 ESC g
Selects LQ fonts.
ASCII Code DC4 DC4 ESC g n
Hexadecimal Value X'14' X'14' X'1B' X'67' n
Decimal Value 20 20 27 103 n
Range 0 = n = 255
If down-line loading is selected, the command is stored and activated as soon as the down-line loading is
canceled.
Boldface is available if the ESC p1 (proportional) is sent.