Printronix S828 - Sets Compressed Printing. (EPSON)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  41 260071‐001A
SI
Sets compressed printing. (IBM)
ASCII Code SI
Hexadecimal Value X'0F'
Decimal Value 15
This command sets horizontal spacing to 17 or 20 cpi. DC2 code cancels this mode and returns spacing to
10 characters per inch.
SI
Sets compressed printing. (EPSON)
ASCII Code SI
Hexadecimal Value X'0F'
Decimal Value 15
This command is accepted at any position within the line. DC2 code cancels compressed printing. The
setting of this command depends on the horizontal spacing previously set
10 CPI . 17 CPI
12 CPI . 20 CPI
DC2 code cancels compressed printing.
SO
Sets double width printing (one line) (IBM/EPSON).
ASCII Code SO
Hexadecimal Value X'0E'
Decimal Value 14
This code causes subsequent data in the same line to be printed as double width characters. It is
cancelled by the CR, LF, VT, FF and DC4 codes or when the buffer is full.