ProgrammerManual PTX‐S828
Chapter3ANSIEmulationCommands 71 260071‐001A
Chapter 3. ANSI Emulation Commands
The following printer commands are supported by this printer according to the ANSI X3.64 emulation.
Most dimensional parameters in ANSI protocol are expressed in “decipoints”. For example:
1 decipoint = 1/720 inch
72 decipoints = 1/10 inch
120 decipoints = 1/6 inch
720 decipoints = 1 inch
2880 decipoints = 4 inches
All parameter values must be expressed as ASCII numeric rather than binary values.
Parameters, within commands with multiple parameters, must be separated by a semicolon “;”.
See “Basic Program Sample” at the end of this chapter and result printed by the printer.
To Next Page
Loading...
