Printronix S828 - ESC ^ Prints a Single Character from the All Characters Table. (IBM)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  43 260071‐001A
ESC ^
Prints a single character from the all characters table. (IBM)
ASCII Code ESC ^ n
Hexadecimal Value X'1B' X'5E' n
Decimal Value 27 94 n
Range 0 = n = 255
This command prints the next character from the all characters table. This sequence prints only one
character from the all character table.
ESC 6
Selects the Character Set 2 (EPSON, IBM).
ASCII Code ESC 6
Hexadecimal Value X'1B' X'36'
Decimal Value 27 54
This command selects the character set 2.
ESC 7
Selects the Character Set 1 (IBM).
ASCII Code ESC 7
Hexadecimal Value X'1B' X'37'
Decimal Value 27 55
This command selects the character set 1.
ESC k
Selects the NLQ fonts. (EPSON)
ASCII Code ESC k n
Hexadecimal Value X'1B' X'6B' n
Decimal Value 27 107 n
Selects one of the available fonts in Letter Quality. If Draft mode is selected when this command is sent,
the new LQ font is selected when the printer returns to LQ printing.
n Types
0 Courier
2 Gothic
ESC R
Selects Nation character set. (EPSON)
ASCII Code ESC R n
Hexadecimal Value X'1B' X'52' n
Decimal Value 27 82 n
Range 0 = n = 13