Printronix S828 - ESC 3 Sets Vertical Spacing to N;180 Inch. (IBM, EPSON)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  21 260071‐001A
ESC 3
Sets vertical spacing to n/180 inch. (IBM , EPSON)
ASCII Code ESC 3 n
Hexadecimal Value X'1B' X'33' n
Decimal Value 27 51 n
Range 1 = n = 255
This sequence sets the vertical spacing to n/180 inch. It is ignored if n is equal to 0.
ESC 3
Sets vertical spacing to n/216 inch. (IBM/EPSON)
ASCII Code ESC 3 n
Hexadecimal Value 1B 33 n
Decimal Value X'27' X'51' n
Range 0 = n = 255
This sequence sets the vertical spacing to n/216 inch.
ESC 4
Sets the current position as top of form (first printable line). (IBM)
ASCII Code ESC 4
Hexadecimal Value X'1B' X'34'
Decimal Value 27 52
This sequence sets the first line of the fanfold paper as the current paper position of the form.
ESC A
Sets variable vertical spacing to n/72 inch. (EPSON)
ASCII Code ESC A n
Hexadecimal Value X'1B' X'41' n
Decimal Value 27 65 n
This command changes the default vertical spacing to n/72 inch. The new vertical spacing value is
immediately activated.
ESC A
Sets variable vertical spacing to n/72 inch. (IBM)
ASCII Code ESC A n
Hexadecimal Value X'1B' X'41' n
Decimal Value 27 65 n
This command changes the default vertical spacing to n/72 inch. The vertical spacing value is stored and
activated only after the ESC 2 code is received.