Printronix S828 - Double Density Dot Graphics Printing (120 Dpi) (IBM;EPSON)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  48 260071‐001A
0 = n2 = 31
0 = p= 255
Terminator code. This command prints dot graphics at 60 horizontal dots per inch (dpi) by 180 vertical dpi.
The parameter values are calculated as follows:
n1 Remainder of the number of columns divided by 256.
n2 Integer result of the previous division.
p1 Sum of the values corresponding to the dots that should be printed in the first column of the
graphics pattern.
p2 Sum of the values corresponding to the dots that should be printed in the second column of the
graphics pattern.
px Sum of the values corresponding to the dots that should be printed in the last column of the
graphics pattern.
ESC L
Double density dot graphics printing (120 dpi) (IBM/EPSON).
ASCII Code ESC L n1 n2 p1 p2 ... px
Hexadecimal Value X'1B' X'4C' n1 n2 p1 p2 ... px
Decimal Value 27 76 n1 n2 p1 p2 ... px
Range 0 = n1 = 255
0 = n2 = 31
0 = p = 255
Terminator code. This command prints dot graphics at 120 horizontal dpi by 180 vertical dpi.
The parameter values should be calculated as follows:
n1 Remainder of the number of columns divided by 256.
n2 Integer result of the previous division.
p1 Sum of the values corresponding to the dots that should be printed in the first column of the
graphics pattern.
p2 Sum of the values corresponding to the dots that should be printed in the second column of the
graphics pattern.
px Sum of the values corresponding to the dots that should be printed in the last column of the
graphics pattern.
ESC Y
Double density dot graphics printing at double-speed graphics (120 virtual dpi) (IBM/EPSON).
ASCII Code ESC Y n1 n2 p1 p2 ... px
Hexadecimal Value X'1B' X'59' n1 n2 p1 p2 ... px
Decimal Value 27 89 n1 n2 p1 p2 ... px
Range 0 = n1 = 255
0 = n2 = 31
0 = p = 255
Terminator code. This command prints dot graphics at 120 horizontal dpi by 180 vertical dpi.
The parameter values should be calculated as follows:
n1 Remainder of the number of columns divided by 256.
n2 Integer result of the previous division.
p1 Sum of the values corresponding to the dots that should be printed in the first column of the