Printronix S828 - Selects;Loads or Parks the Fanfold from the Front 2 Path

ProgrammerManual PTX‐S828
Chapter2NativeEmulationCommands 67 260071‐001A
DC4 DC4 ESC N
Selects/loads or parks the fanfold from the Front 2 path.
ASCII Code DC4 DC4 ESC N n
Hexadecimal Value X'14' X'14' X'1B' X'4E' n
Decimal Value 20 20 27 78 n
Range 0 = n= 1
n Selection
0 Selects and loads the fanfold from the Front2 path. If the paper is present, the printer automatically
parks the fanfold that is not requested before loading the new one (after having pressed the PARK
key in response to the TEAR IF NECESS/PARK PAPER message).
1 Parks the fanfold loaded from the Front2 path to allow the tear off function (after having pressed the
PARK key in response to the TEAR IF NECESS/PARK PAPER message).
DC4 DC4 ESC R
String rotation.
ASCII Code DC4 DC4 ESC R n string EM
Hexadecimal Value X'14' X'14' X'1B' X'52' n string EM
Decimal Value 20 20 27 82 n string EM
n Selection
0 No rotation.
1 Rotation at 0°
2 Rotation at 90°
3 Rotation at 180°
4 Rotation at 270°
DC4 DC4 ESC r
Digit rotation.
ASCII Code DC4 DC4 ESC r
Hexadecimal Value X'14' X'14' X'1B' X'72'
Decimal Value 20 20 27 144
This command is used to set the required character rotation to be applied to the selected font.
n Selection
0 No rotation.
1 Rotation at 0°
2 Rotation at 90°
3 Rotation at 180°
4 Rotation at 270°
DC4 DC4 ESC T
Selects/loads or parks the fanfold from the Front1 path.
ASCII Code DC4 DC4 ESC T n
Hexadecimal Value X'14' X'14' X'1B' X'54' n
Decimal Value 20 20 27 84 n
Range 0 = n = 1