Printronix S828 - Selects the Score Line. (IBM 2381 + Only)

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  31 260071‐001A
d2 Line
0 Cancel score line
1 Single continuous line
2 Double continuous line
5 Single broken line
6 Single broken line
Any combination of scoring may be used at the same time and are independent of each other. Graphics
characters are not scored.
ESC[-
Selects the score line. (IBM 2381 + only)
ASCII Code ESC [ - n1 n2 loc type
Hexadecimal Value X'1B' X'5B' X'2D' n1 n2 loc type
Decimal Value 27 91 45 n1 n2 loc type
Range n1 =2
n2 =0
This command selects several forms of overscore, underscore, and strikethrough.
To select loc: To select type:
loc Selection type Selection
1 Underscore 0 Cancles Line
2 Strikethrough 1 Single Line
3 Overscore 2 Double Line
255 Cancels all score selections
ESC :
Sets 12 CPI. (IBM)
ASCII Code ESC :
Hexadecimal Value X'1B' X'3A'
Decimal Value 27 58
This is a terminator code. It causes all data present in the print buffer to be printed. Subsequent data is
printed at 12 cpi. This command is accepted at any position within the line. The setting of another
horizontal spacing resets this command.
ESC <
Prints characters for one line from left to right. (IBM XLIII, EPSON)
ASCII Code ESC <
Hexadecimal Value X'1B' X'3C'
Decimal Value 27 60
This command causes the printing of one line from left to right.