Printronix S828 - Download Character

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  44 260071‐001A
This code causes the national character set to be selected according to the parameter n. See the following
table:
n National Character Sets n National Character Sets n National Character Sets
0 USA 5 Sweden 10 Denmark-II
1 France 6 Italy 11 Spain-II
2 Germany 7 Spain-I 12 Latin America
3 United Kingdom 8 Japan
4 Denmark-I 9 Norway
ESC t
Selects characters table. (EPSON)
ASCII Code ESC t n
Hexadecimal Value X'1B' X'74' n
Decimal Value 27 116 n
Range 0 = n = 3
Selects the upper half (from 128 to 255) from the character table.
n Character Tables
0 Standard Italic Character Set
1 ASCII Character Set
2 Remaps DLL Character Set from position 0-127 to 128-255
Download Character
ESC %
Selects user-defined character set. (EPSON)
ASCII Code ESC & n
Hexadecimal Value X'1B' X'25' n
Decimal Value 27 37 n
This command switches between normal (resident) and user-defined (downloaded) characters:
n Selection
1 Selects the use of downloaded character set in RAM
0 Selects the use of resident character set in ROM
ESC &
Defines user-defined characters. (EPSON)
ASCII Code ESC & NUL n m [ a d1 ... d11 ]
Hexadecimal Value X'1B' X'26' 00 n m [a d1 ... d11 ]
Decimal Value 27 38 00 nm a [ d1 ... d11 ]
Range 0 <= n <= 255
0 <= m <= 255
n<= m
0 <=a <= 255
0 <=d <= 255