Printronix S828 - Page 89

ProgrammerManual PTX‐S828
Chapter3ANSIEmulationCommands 87 260071‐001A
p7: Wide Space Width
Default width value: 7 (120, 144 dpi), 8 (180 dpi)
p8: Intercharacter Space Width
Default width value: 3 (120, 144 dpi), 4 (180 dpi)
p9: Rotation
p9 FUNCTION
0 0 degrees using current font
1 0 degrees using special HRI font
2 90 degrees using special HRI font
3 180 degrees using special HRI font
4 270 degrees using special HRI font
p10: Horizontal Print Density for Bar Codes Printed
p10 FUNCTION
1 120 dpi horizontal density
2 144 dpi horizontal density (Reserved)
3 180 dpi horizontal density
p11: Check Digit
p11 FUNCTION
0 No check digit requested (default)
1 Check digit requested
p12: Human Readable Font -Reserved
p13: Bar Code Height (in 1/24th-inch increments) -Reserved