Procom DVS-21 - System Clock

To Next Page

To Previous Page

User Guide

DVS-21

02/2018 • V.1.0 • L. Wolle

25/131

Professional Communication & Service GmbH • Technical changes reserved.

Add. fault report output

The standard fault report of a system is made by means of the SV01 module.

Should a general fault be processed in addition, this takes place by using a

Line or Flags.

Check call stations (0=not)

Connected stations are interrogated at the programmed interval. If it is no

longer possible to address a station, then an FSK fault report is triggered on

the associated port of the 4NSA module and a related general fault report on

the SV01.

Speech time limit

(0=none)

Active intercom calls are disconnected after the specified time. It is only

possible to continue the call for the set time once a new connection has been

established.

Fault report OR Flag

This Flag triggers an SV01 general fault if it is activated.

Battery control, additional output

System clock

automatic switch-over to West European summertime

Activates the internal correction of the system clock according to the official determination of Summer-

/Winter-time change-overs.