Procom DVS-21 - Programs for AF-transfer; 9.1 Overview

User Guide
DVS-21
02/2018 • V.1.0 • L. Wolle
74/131
© 2017 ProCom
®
Professional Communication & Service GmbH • Technical changes reserved.
Measurement
Start measuring
starts a reference measurement
Control measuring
starts a comparative measurement
The reference value of the measurement is only stored in the configuration file when saved. The
configuration file must be transferred to the system, in order for the impedance test to operate with this
value.
9 Programs for AF-transfer
9.1 Overview
Explanation of the parent configuration boxes of many AF-programs!
Priority, Audio channel, Audiokompression
Priority
There are 255 levels available, with 1 being the highest. Priorities are dealt with on
destination. If a program finds an occupied destination, the priorities of both
programs are compared. If the priority of the new connection is higher, the existing
connection will be displaced.
Fixed audio channel
In programs with this channel box is the possibility to use a fixed audio channel
instead of a dynamic one. It is useful in conjunction with a DSS1 because this
module works with eight predefined channels.
Codec
Audio compression method of the codec for the actual connection.
The options are: µLaw (default), ADPCM (7kHz) and aLaw
Please note: Depending on the firmware of the module and the equipped codec
type, different combinations of audio compression methods are available.
Codec IC (with pins)
µLaw and aLaw
Codec IC (SMD)
µLaw, aLaw and ADPCM (7kHz)