User Guide
DVS-21
02/2018 • V.1.0 • L. Wolle
© 2017 ProCom
®
Professional Communication & Service GmbH • Technical changes reserved.
By specifying the modem settings for remote maintenance, the system can be configured and monitored
remotely.
Modem fault report options
The type of modem line and the dialing process must be specified. Number of
rings until pick-up. The Detection of new call (sec) field specifies how rapidly
the system can/may accept consecutive incoming calls. The acceptance of
incoming calls can be blocked by means of the NAND call flag field. The Flag
(OUT) is triggered if a connection is established successfully.
Special
This page enables special configurations for special cases. It is recommended that changes be made
only by specialists!
6.2 Call stations and devices
Overview of all the stations of a system.
The creation of new or the configuration of existing stations takes place here.
The always show all option lists all stations in the left-hand overview, or only the stations of the type
marked in the right-hand selection.
To Next Page
Loading...