Procom DVS-21 - Page 93

User Guide
DVS-21
02/2018 • V.1.0 • L. Wolle
93/131
© 2017 ProCom
®
Professional Communication & Service GmbH • Technical changes reserved.
Long distance line
Specifications regarding the module to which the Long distance line is connected.
In the case of Transmission via 2Mbps, the Transmission line controlling and the Transmission line AF
are identical.
Address, Port
Address and port of the respective long-distance line
Line
This Line is switched on by the source when the PTT key is
pressed.
The program in the destination reacts to the Line and switches
to receive.
It corresponds to the Call line in the Remote - Intercom
program.
Here the program supports an expanded Lines range.
(240 Lines and 192 lines in the case of Transmission via
2Mbps)
Busy line
Line for transmission of the status Busy.
Group busy indication
The program switches to the Busy status. Only if none of the
subscribers has a Busy status, is the connection set up.
Address partial group despite being busy
The connection is set up, even if individual subscriptions have a
Busy status.
Input Busy flag
[IN] The program is set to a Busy status. The associated key is
illuminated.
There are situations in which not all programs detect the status
automatically. In these cases the status must be conveyed
explicitly.
Output Busy flag
[OUT] The flag is switched on if the program switches to the
Busy status.
Flag (NAND)
[IN] The program can be turned off by this flag or switching on
can be prevented.