VisiJet® FTI Material Cartridge Procedure
Uncured material waste is classified as regulated, and in some areas hazardous, thereby requiring special packaging, transportation and disposal.
Refer to your local local environmental regulatory agency.
Applicable material "waste" includes cartridges (empty or full). Any cleaning supplies used to clean up uncured material should be disposed of in
the same manner as the uncured material. To identify which disposal requirement applies, contact the local waste disposal service provider. (The
local environmental regulatory agency should have a list of qualified providers in your area.) Give the disposal service provider a copy of the
material's MSDS and the SNUR (Significant New Use Regulation - U.S. only). The service will provide a report, indicating the disposal
requirements that apply, as well as a quotation for regularly scheduled pickups.
3D Systems assumes no liability or responsibility for proper disposal of the uncured material. Proper disposal of the uncured material is the sole
responsibility of the user.
To Next Page
Loading...
