VisiJet® FTI Material Handling
Upon receipt of the part material shipment, inspect the carton for signs of physical damage and evidence of leakage on the exterior. If leakage is
observed, do not open carton; immediately contact 3D Systems' Customer Support Hotline. If leakage is not present, store materials in their
material kits until they are ready to use. Materials should be kept indoors in a cool, dry area with adequate ventilation with temperatures between
16 °C (60 °F) and 27 °C (80 °F). DO NOT EXCEED A MAXIMUM STORAGE TEMPERATURE OF 35 °C (95 °F).
Keep materials away from direct sunlight, heat, flames and other direct light or UV energy sources. For optimal results, keep stored cartons
closed and sealed until the cartridge is ready for use. Authorized 3D Systems VisiJet® FTI Material should only be used in the printer.
To Next Page
Loading...
