In the
‘Priming time’
menu, you can select how long the metering
pump is to prime once
[Priming]
has been pressed.
In operation, the stroke length can be changed
more easily using the "Priming time" display:
–
Press [Priming] - the pump starts to prime.
–
Turn the [Clickwheel] to set the priming time.
–
Press the [Clickwheel] to save the priming
time.
11.2.12
‘Set time’
‘Menu / Information
è
Settings
è
Set time
è
...’
You can set the time in the
‘Set time’
menu.
1. Use the dial to adjust a figure.
2.
Use
[Priming]
to move to the next figure.
Under
‘Auto. Summertime’
you can select whether you wish to
change over to
‘Summertime’
.
You can also state when the pump is to change to and from
‘Summertime’
.
Check under
‘Location’
whether the pump is also set to your
‘hemisphere’
of the world.
11.2.13
‘Date’
‘Menu / Information
è
Settings
è
Date
è
...’
You can set the date in the
‘Date’
menu.
11.3 Timer
‘Menu / Information
è
Timer
è
...’
–
Please first read this chapter completely to
gain an overview. You will then understand the
timer better when working through the chapter.
The timer gamma/ XL can do the following at predefined times and
intervals or event-dependent:
n open / close the relays
n switch the level of a Config I/O output
n be triggered by the level at a Config I/O input
n start a delayer
n switch operating mode
n operate the pump work at a defined capacity or stroke rate /
stroke length
Set up /
‘Menu’
78
To Next Page
Loading...
Need help?
General
