ProSoft MVI56-PDPMV1 - Mailbox Message: Set Slave Address

Mailbox Messaging MVI56-PDPMV1 ♦ ControlLogix Platform
User Manual PROFIBUS DPV1 Master
Page 154 of 251 ProSoft Technology, Inc.
3.5.4 Mailbox Message: Set Slave Address
This command allows you to set the node address of a slave (if supported).
Note: The message data size depends on the actual slave implementation. Range 0 to 240 bytes.
Parameter
Description
Command Initiator
Application
Command Name
SET SLAVE ADDRESS
Command Number
0600h
Fragmented
No
Extended Header Data
Fault information may be returned in the header of the response.
Command and Response Layout: Set Slave Address
Command
Response
Message ID
(ID)
(ID)
Message information
4002h
0002h
Command
0006h
0006h
Set Slave Address
Data size
(Size of data)
(Size of data)
No. of Slave Data bytes (n)
Frame count
0001h
0001h
Frame number
0001h
0001h
Offset high
0000h
0000h
Offset low
0000h
0000h
Extended word 1
Current
Slave Addr.
New Slave
Address
Current
Slave Addr.
New Slave
Address
Extended word 2
Slave Ident Number
Slave Ident Number
Extended word 3
No_add_
Chg
-
No_add_
Chg
Extended word 4
-
-
Extended word 5
-
Error Code 1
Error Code 2
Extended word 6
-
Error Code 3
Error Code 4
Extended word 7
-
Return Code
Extended word 8
Fault Information
Message Data byte 1
Slave Data 1
Slave Data 1
Message Data byte 2
Slave Data 2
Slave Data 2
Message Data byte 3
Slave Data 3
Slave Data 3
...
...
...
Message Data byte "n"
Slave Data n
Slave Data n