ProSoft MVI56-PDPMV1 - Mailbox Message: Stop Slave

Mailbox Messaging MVI56-PDPMV1 ♦ ControlLogix Platform
User Manual PROFIBUS DPV1 Master
Page 168 of 251 ProSoft Technology, Inc.
3.5.11 Mailbox Message: Stop Slave
This mailbox message stops a selection of slaves from the processing cycle.
This message is allowed in all Operation modes (STOP, CLEAR and
OPERATE).
Note: The message will be accepted even if one or several slaves are not part of the configuration
and can therefore obviously not be stopped. However, the application can find out about this
situation by evaluating the "Fault information" and "Message data words" of the response.
Command and Response Layout: Stop Slave
Command
Response
Message ID
(ID)
(ID)
Message information
4002h
0002h
Command
000Ch
000Ch
Stop Slave
Data size
007Eh
007Eh
Frame count
0001h
0001h
Frame number
0001h
0001h
Offset high
0000h
0000h
Offset low
0000h
0000h
Extended word 1
-
-
Extended word 2
-
-
Extended word 3
-
-
Extended word 4
-
-
Extended word 5
-
-
Extended word 6
-
-
Extended word 7
-
Additional Fault Information
Extended word 8
-
Fault Information
Message data word 1
Slave 0
Slave 1
Slave 0
Slave 1
Message data word 2
Slave 2
Slave 3
Slave 2
Slave 3
Message data word 3 to 62
...
...
...
...
Message data word 63
Slave 124
Slave 125
Slave 124
Slave 125