Pulsar SLUDGE FINDER 2 User Manual

Page 98
Alarm ID
Description
Setpoints
5= LoLo
Same as 4=Lo, but
different identifier.
6= In bounds
Relay goes “ON” if
value is inside the zone
between the two
setpoints.
Relay Setpoints,
P213, 223, 233,
243, 253, 263 and
P214, 224, 234,
244, 254, 264 can
be set in any order
as the unit ‘knows’
that you are setting
an in bounds alarm.
7= Out of bounds
Relay goes “ON” if
value is outside the zone
between the two
setpoints.
Relay Setpoints
P213, 223, 233,
243, 253, 263 and
P214, 224, 234,
244, 254, 264 can
be set in any order
as the unit ‘knows’
that you are setting
an out of bounds
alarm.
The fourth parameter and the fifth parameter for each relay set the Alarm
“ON” and “OFF” points. For a high alarm the “ON” is set higher than “OFF”.
For low alarm then “ON” is set lower than “OFF”. See the appropriate alarm
ID, table (P212, 222, 232, 242, 252, 262) for further information.
When P211, 221, 231, 241, 251, 261 = 3 (Loss of Echo), 4 (Loss of Clock), 5 (Wiper
Fault) 6 (Hi – Floc Alarm) or 7 (Service Interval Alarm)
These parameters have no function and will not be displayed.
P211, 221, 231, 241, 251, 261 = 1 (Level) or 2 (Temperature)
P213, P223, P233, P243, P253, P263 - Relay Setpoint 1
Determines the “ON” or “OFF” point for the alarm according to the ID selected.
P214, P224, P234, P244, P254, P264 - Relay Setpoint 2
Determines the “ON” or “OFF” point for the alarm according to the ID selected.

Pulsar SLUDGE FINDER 2 Specifications

General

Brand	Pulsar
Model	SLUDGE FINDER 2
Category	Measuring Instruments
Language	English