Page 59
Once you have reached the relevant section, scroll down the parameter list to
highlight the parameter you wish to edit and press ENTER to access the parameter
options. When you are at parameter level, the options for that parameter will be
displayed on the screen. If the parameter has preset options then scroll up or down,
with the up/down arrow keys, or press the designated number key (displayed on
the left hand side) to highlight the option, then press ENTER to save. If the
parameter requires you to enter a value within a particular range, the range options
will be displayed with a box to enter the value. Use the numeric keypad to enter
the required value following the onscreen prompts and press ENTER to save.
When you have finished, press CANCEL to go back to the previous menu level.
When you have reached the top level, press the CANCEL button again, the Sludge
Finder 2 will ask for confirmation before allowing you return to run mode. This
is done by pressing ENTER at the display prompt.
Directly Editing Parameters
If you already know the number of the parameter that you wish to look at or edit,
simply type the number in at any time while you are in the menu system. Thus, if
you are in either the menu or sub-menu level by pressing a numeric key, you can
enter the parameter number directly and jump straight there. You cannot type a
parameter number whilst at parameter level, only at one of the two menu levels.
When you are at parameter level, the options for that parameter will be displayed
on the screen. If the parameter has preset options then scroll up or down, with the
up/down arrow keys, until the required option is highlighted, then press ENTER to
change it. If the parameter requires a value within a particular range, the range
options will be displayed with a box to enter the value. Use the numeric keypad to
enter the required value following the onscreen prompts and press ENTER to save
it.
Once you have accessed a parameter, you can either just look at it, or change it.
Once a parameter has been changed, press ENTER and you will see the parameter
value changed in the parameter list. If you press CANCEL then you will be returned
to the parameter list with no change to the values.
To Next Page
Loading...
Need help?
General
