9 – Device Security Configuration
Managing Groups
59183-03 A 9-13
A
Add Members to a Group
Adding a member to a group involves specifying a group, the member worldwide
name, and the member attributes. The member attributes define the
authentication method, encryption method, secrets, and fabric binding, depending
on the group type.
îš„ For ISL member attributes, refer to Table 14-2.
îš„ For Port member attributes, refer to Table 14-3.
îš„ For MS member attributes, refer to Table 14-4.
Enter the Group Add command to add a member to a group:
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security) #> group add Group_1
A list of attributes with formatting and default values will follow
Enter a new value or simply press the ENTER key to accept the current value
with exception of the Group Member WWN field which is mandatory.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Name Group_1
Group Type ISL
Member (WWN) [00:00:00:00:00:00:00:00] 10:00:00:c0:dd:00:90:a3
Authentication (None / Chap) [None ] chap
PrimaryHash (MD5 / SHA-1) [MD5 ]
PrimarySecret (32 hex or 16 ASCII char value) [ ] 0123456789abcdef
SecondaryHash (MD5 / SHA-1 / None) [None ]
SecondarySecret (40 hex or 20 ASCII char value) [ ]
Binding (domain ID 1-239, 0=None) [0 ]
Finished configuring attributes.
To discard this configuration use the security cancel command.
To Next Page
Loading...
Need help?
General
