Qlogic SANbox 5600 Series

14 – Command Reference
Zoning Merged
14-218 59183-03 A
S
Zoning Merged
Displays the contents of the merged zone set, or saves the merged zone set to
the non-volatile zoning database.
Authority Admin session for the Capture keyword.
Syntax zoning merged
capture
Keywords capture
Saves the merged zone set to the non-volatile zoning database. You must enter
the Zoning Save command afterwards to save your changes. If you omit this
keyword, this command displays the contents of the merged zone set.
Examples The following is an example of the Zoning Merged command:
SANbox #> zoning merged
*********************************************************************
To permanently save the merged database locally, execute the
'zoning merged capture' command. To edit the merged database
use the ’zoning edit merged’ command. To remove the merged database
use the ’zoning restore’ command.
**********************************************************************
Merged (unsaved) Zoning Information
ZoneSet Zone ZoneMember
------- ---- ----------
ZS1
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Z2
10:00:00:c0:dd:00:b9:fb
10:00:00:c0:dd:00:b9:fc
The following is an example of the Zoning Merged Capture command:
SANbox (admin) #> zoning merged capture
This command will overwrite the configured zoning database in NVRAM.
Please confirm (y/n): [n] y
The merged zoning database has been saved.