Qlogic SANbox 5600 Series

14 – Command Reference
Show Setup Snmp
14-174 59183-03 A
S
Show Setup Snmp
Displays the current SNMP settings.
Authority None
Syntax show setup snmp
common
trap
Keywords common
Displays SNMP configuration parameters that are common to all traps. To display
common and trap-specific parameters, omit the keyword. Refer to Table 14-29 for
descriptions of the common configuration parameters.
trap
Displays trap-specific SNMP configuration parameters. To display common and
trap-specific parameters, omit the keyword. Refer to Table 14-30 for descriptions
of the trap-specific configuration parameters.
Examples The following is an example of the Show Setup Snmp Common command:
SANbox #> show setup snmp common
SNMP Information
----------------
SNMPEnabled True
Contact <sysContact undefined>
Location <sysLocation undefined>
Description SANbox 5600 FC Switch
ObjectID 1.3.6.1.4.1.1663.1.1.1.1.17
AuthFailureTrap True
ProxyEnabled True
SNMPv3Enabled False
The following is an example of the Show Setup Snmp Trap command:
SANbox #> show setup snmp trap 1
SNMP Information
----------------
Trap1Address 10.0.0.254
Trap1Port 162
Trap1Severity warning
Trap1Version 2
Trap1Enabled False