14 – Command Reference
Set Setup Services
59183-03 A 14-115
A
Set Setup Services
Configures services on the switch.
Authority Admin session
Syntax set setup services
This command prompts you in a line-by-line fashion to enable or disable switch
services. Table 14-28 describes the switch service parameters. For each
parameter, enter a new value or press the Enter key to accept the current value
shown in brackets.
NOTE:
Disabling TelnetEnabled or GUIMgmtEnabled will immediately terminate the
current Telnet or switch management session. Disable services with caution;
it is possible to disable all Ethernet access to the switch.
Table 14-28. Switch Services Settings
Entry Description
TelnetEnabled Enables (True) or disables (False) the ability to manage the
switch over a Telnet connection. Disabling this service is not
recommended. The default is True.
SSHEnabled Enables (True) or disables (False) Secure Shell (SSH) con-
nections to the switch. SSH secures the remote connection to
the switch. To establish a secure remote connection, your
workstation must use an SSH client. The default is False.
The SSH service requires the Fabric Security license key To
purchase a license key, contact your authorized maintenance
provider or authorized reseller.
GUIMgmtEnabled Enables (True) or disables (False) out-of-band management
of the switch with Enterprise Fabric Suite 2007 and the Appli-
cation Programming Interface. If this service is disabled, the
switch can only be managed inband or through the serial
port. The default is True.
To Next Page
Loading...
Need help?
General
